Hi,
Re RB834.
Is it possible to configure the accessory port as two inputs and four outputs?
If so, what is the procedure?
Best regards,
Stefan
Hi,
Re RB834.
Is it possible to configure the accessory port as two inputs and four outputs?
If so, what is the procedure?
Best regards,
Stefan
Technically, yes. The feature is not supported in SuperLab, but if you are programming your own code, then it is possible.
The RB-834 is an XID device. The XID command set is described at
Specifically, check out the A4 command:
Hi,
Many thanks for the reply.
Regards,
Stefan