sending event code to EEG for response

SuperLab SuperLab 5 Support
1

I made a Flanker task and I want to record EEG during the task. I was able to set up event codes that go into the EEG for the stimuli that I’m presenting, but I am not sure how to set up event codes for when the participant responds. Ideally, I would like to send one code for correct responses and one for incorrect responses. However, if I could send one code for a left response and one code for a right response that would be alright. Any suggestions would be appreciated.

Thanks,
Emily

2

In the Feedback tab of the event editor, there are choices to present events depending on choice of response as well as correctness. Is this what you are looking for?