Unable to reset parameter, no feedback options checked

SuperLab SuperLab 5 Support
1

After every run, I see a dialogue box saying “Unable to reset parameter [no parameters].” I looked at the other thread in this forum about that issue, and their problem seemed to be an issue with feedbacks. I went through every event, and no feedback option is checked anywhere. The “reset parameter” condition is always grayed out and unused. I am not using parameters, though I tried making one, a dummy counter. Kept the error message.

What else could be causing this problem?

Thanks,
Susan

2

If feedback is not being used, then this message is coming from a rule, under the Rules tab. The Rules tab can be found under the Block Editor and the Trial Editor. If you cannot find it, please post your experiment and we can assist you.