Announcement

Collapse
No announcement yet.

Trouble Sending Triggers From E-Prime with C-Pod

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Trouble Sending Triggers From E-Prime with C-Pod

    I recently purchased the c-pod to allow me to send triggers from E-prime 2.0 to ANT Neuro's EEG amplifier. The USB serial port for the c-pod shows up under device manager, but E-prime isn't able to send triggers through it. I wasn't sure if there is some extra step I might be missing, but any advice at all would be helpful.

  • #2
    Are you getting an error message from E-Prime? where exactly is the trouble spot, e.g. is E-Prime unable to open the serial port, or can it open it but pulses that you send using E-Basic are not being delivered?

    Comment


    • #3
      There is no error message, and I can add the serial port to the experiment as (COM 5). I've tried adding task events to send triggers based on terminating responses on a slide on e-prime using writebyte. The triggers just don't seem to be sending. The light on the c-pod does not go off, nor does the EEG record any trigger.

      Comment


      • #4
        Please see the E-BASIC code that’s posted on this page:

        It will work largely as is with c-pod.

        Comment

        Working...
        X