Hardware


Matlab Support A place for Matlab users to ask about using Cedrus response devices and StimTracker General A place to discuss Cedrus hardware (response pads, SV-1 voice key)
Topic Replies Activity
About the Hardware category 1 April 18, 2020
StimTracker Produces High Amp Noise on ANT 8 December 12, 2019
Phantom responses being recorded by Lumina 3G (using PsychoPy) 1 November 17, 2019
Installing RB530 on Windows 10 64bit 2 September 23, 2019
Recommended serial port hardware (will this work?) 2 June 4, 2019
Lumina Line 4 Button pad button issue 2 April 20, 2019
Response Box timeout settings and framerate limitations. 2 February 12, 2019
Lumina as keyboard no response 5 December 17, 2018
Trouble Sending Triggers From E-Prime with C-Pod 4 December 13, 2018
Signal reception 4 December 13, 2018
Settings for continuos button press 7 November 21, 2018
Sending event markers in E-prime to Nirx through cedrus c-pod 2 November 12, 2018
Performance issues with Response Pad RB-740 and Superlab 7 September 21, 2018
set up 7 September 13, 2018
Artifacts in EEG recoding from button press 16 June 18, 2018
Light sensor not detected 3 May 11, 2018
StimTracker Trigger Artifact in g.tec g.USBamp (v3)? 2 May 4, 2018
SuperLab 6 and X6 can't recognize 830 1 January 24, 2018
Stim Tracker and pyxid 1 January 23, 2018
Stimtracker event markers not being sent 1 December 1, 2017
RB-740 with Psychopy2 builder 7 November 27, 2017
Stemtracker and XID mode 1 November 9, 2017
c-pod with Superlab 5.0 4 November 7, 2017
RB-540 and Presentation 1 October 17, 2017
Lumina LSC400 controller LED (for yellow button) on continuously and non responsives 2 August 14, 2017
Master clock to control Stimtracker through TTL input 10 August 14, 2017
Macbook Pro 2016 / 2017 usb-c port 6 June 22, 2017
Stimtracker and Curry 8 6 April 13, 2017
Trigger names do not show as originally labelled - or not at all! 2 February 28, 2017
RB-830 set up 5 February 27, 2017