Thread Tools  
Junior Member
Join Date: Sep 2015
Location: University of Essex
ebroggin is on a distinguished road Posts: 4

I would like to send triggers to Acquire (EEG neuroscan) with the Cedrus RB-730 and the accessory connector (ethernet to parallel port connected to the Neuroscan) in a Superlab experiment, but when I go the Input Participant to set up, the RB is detected fine and I set up the RB for general purpose output.

However, when I save the Superlab experiment and I reopen it, it switch to reflective state and it does not send the triggers anymore.

If it matters, at the beginning of the trials the digital output is set to 0 and them to and high.

Any suggestion on how to save the state of the RB-730 for general output purpose or what it may be wrong?

Many thanks,

Reply With Quote
general output purpose, rb-730, trigger
Thread Tools
Posting Rules
Forum Jump:
Copyright Cedrus Corporation, 1991-2014.
All times are GMT -7. The time now is 01:38 AM.