Dear All,
we have recently acquired a Philips scanner with a SensaVue system, i.e. a stand-alone presentation system that integrate a Lumina controller.
I would like to know if there is any way to obtain the behavioral response (button presses) and the trigger signal directely from the Lumina controller. I need to use them with my laptop and the NBS Presentation software.
If so, how could I connect my laptop with the Lumina? It is only needed a USB cable or I should use some other port/cable?
Thanks in advance for your precious help.
L.Fuzi
|
|
|||||||||
|
|||||||||
|
|||||||||
|
|||||||||||
You will need:
As for the trigger from the scanner, you can have that go directly into our Lumina controller, which would then forward that information on to Presentation. |
|||||||||||
|
|||||||||||
|
|||||||||
Thank you for your response
|
|||||||||
|
|||||||||
|
|||||||||
Dear HisHam,
I have followed your instruction, but I cannot be able to select a USB input on Prestentation. My Presentation (version 18.3) does not include a USB input, but only serial and parallel inputs. How can I fix that? Thanks in advance for your suggestions. Lino |
|||||||||
|
|||||||||
|
|||||||||||
From Presentation’s point of view, it is serial port. This is because, when the USB driver is installed, it emulates a serial port.
|
|||||||||||
|
|||||||||||
| Reply | « Previous Thread - General - Next Thread » |
| Tags |
| behavior, lumina, presentation, trigger |
| Thread Tools |
