Thread Tools  
Junior Member
Join Date: Jan 2008
beatrice is on a distinguished road Posts: 19
RB 834 output, Posted January 28th, 2008 #1
I haven't purchased it yet, but I would like to use the RB 834 to do 2 things. I'd like it to allow input to Superlab, but also to provide a signal to my physiological recording equipment (PowerLab) through either an 8-pin DIN connector or a BNC type connector. This would allow me to insert a comment into the recording for each stage of the experiment. What do I need in addition to the RB 834 and the corresponding cable to do this?
Reply With Quote
Join Date: Aug 2006
Location: San Pedro, CA
Hisham is on a distinguished road Posts: 1,216
Posted February 6th, 2008 #2
Hi Beatrice,

Our response pads have an Accessory Connector on the back that, by default, will provide signals whenever a key is pressed. General notes:
  • Physically, the Accessory Connector is an RJ45 connector, identical to the Ethernet (network) connector. These cables are very easy to find.

  • Only 6 output lines are available. See this tech support note for the details.

Reply With Quote
Thread Tools
Posting Rules
Forum Jump:
Copyright Cedrus Corporation, 1991-2014.
All times are GMT -7. The time now is 04:01 AM.