I currently have the Lumina LSC-400B controller connected to a Windows computer by serial port. I'm also receiving triggers from an MRI scanner.
I need to trigger another device that inputs a 5 V TTL signal. I want to send the signal through the Accessory Connector on the LSC-400B. The documentation says this inputs/outputs a TTL signal. I'm writing the program in python.
Can I write a signal to be output from the Accessory Connector on the LSC-400B? Do I need to send any special signals to the LSC-400B? What mode/speed do I need to set the LSC-400B to?
Thanks a lot for any help!!!