Cedrus Community Forums

Cedrus Community Forums (http://community.cedrus.com/index.php)
-   New Feature Suggestions (http://community.cedrus.com/forumdisplay.php?f=12)
-   -   For Data viewer (http://community.cedrus.com/showthread.php?t=738)

AlexC March 1st, 2009 01:55 PM

For Data viewer
 
Hello, I've been using the data viewer, and one thing that would be nice is the ability to not output all of the columns. It makes the output file look overly cluttered and I routinely have to delete the same columns.

Also, when transposing the data (and im not sure this could work) have each participent's data below the one above it, instead of next to it. This would make entering the data into SPSS or even excel much much easier.

Thanks,
Alex

Kelly March 3rd, 2009 04:43 PM

Excluding Columns from DataViewer Output
 
Thank you for your feature suggestion. I agree with you that the ability to exclude columns from the merged/saved output would be a good new feature. (Unfortunately, you are correct to note that this is not currently available).

However, there is something that you can do from within SUPERLAB (not DataViewer) that might help alleviate some of your hassles with "column clutter."

SuperLab allows you to disable Trial Variable columns in the output. If you have not tried this setting yet, then maybe this will benefit you:

Open the experiment in SuperLab. Go to "Experiment >> Trial Variables." In the "Trial Variables" window, select any one of the variables. "Reaction Time" or "Screen Location" are two examples that will probably be available on the list. Choose one. Click "Edit" to open the "Edit Trial Variable" window. In the "Edit Trial Variable" window, choose the "Options" tab. Remove the check mark in the box next to "Save variable's value in the collected data file." Click "OK" to close that window. Save the experiment. Those columns will not appear in future output files.

Regarding your other comment about formatting data for SPSS, you might want to read through the following thread:

http://community.cedrus.com/showthread.php?t=502

There are several suggestions there from at least three different respondents. The suggestions involve tools other than DataViewer, however.

DataViewer treats the SuperLab output as a two-dimensional grid, and "transpose" is currently the only transformation provided. I believe that what you might need for SPSS is something more like a "pivot table" than like a two-dimensional grid. Is that correct?


All times are GMT -7. The time now is 02:47 PM.


Copyright Cedrus Corporation, 1991-2014.